vernier caliper

1. Branch growth for internode length ( IL) and basal diameter ( BD) was determine by vernier caliper, and their partial correlations with respect to the whorls were calculated.
   结果表明，同一年份枝条节间长、基径生长量随轮枝层的下降呈波动式下降趋势。
2. A vernier caliper and a personal computer were used for measurements and calculations.
   测量使用游标卡尺，计算使用微型计算机。
3. Methods: The three-dimensional craniomaxillofacial measurement instrument was designed and made up with vernier caliper and micrometer technique.
   方法：使用游标卡尺和千分尺的工艺，设计并制作三维颅颌面测量器；
4. Corner and edge breakage, use vernier caliper to measure the defect's length, width and height, check the defect quantity by eye.
   缺角和崩边用游标卡尺测量缺陷的长度、宽度、高度；目测缺角个数。
5. Methods to measure the internal diameter by vernier caliper, and observe it by morphology.
   方法用游标卡尺测量血管内径，并进行形态学观察。
6. Computer data acquisition software system for vernier caliper base on USB interface
   USB接口为基的游标卡尺计算机数据采集软件系统开发
7. Methods Vernier caliper and Digora digital imaging system were used to measure 20 sets of deciduous anterior cross-bite dentition respectively and the results were compared.
   方法分别用电子游标卡尺和Digora数字影像系统测量20副前牙反（？）乳牙列模型，比较两种方法的各项测量值并作统计分析。
8. The length, width and thickness of the ligamentous structures of the TFCC were measured with vernier caliper, and each marginal length and thickness of articular disc of the wrist were investigated too.
   用游标卡尺测量韧带的长度、宽度和厚度及腕关节盘的桡侧缘、掌侧缘及背侧缘的长度和厚度。
9. The level of medial epicondyle of femur was taker as mark point to measure the position, thickness and length of all muscle nerves and their final branches with vernier caliper ( Accuracy is 0.02mm), straightedge ( Accuracy is 1mm), compasses and protractor.
   用游标卡尺（精确度0.02mm），直尺（精确度1mm），圆规和量角器，以股骨内上髁水平为标志点对各神经肌支及其终支的位置、粗细和长度进行测量。
10. At the temporomandibular joint level, an anatomical relationship of the temporomandibular joint and related structures was observed. The articular disc in thickness was measured with vernier caliper.
    在经颞下颌关节层面上，观察颞下颌关节及其周围结构的解剖学关系，用游标卡尺测量关节盘的厚度。
11. Gauge and vernier caliper both have the advantage of high efficiency, however vernier caliper is only qualified for applications of relatively lower precision.
    塞规和游标卡尺都具有效率高的优点，游标卡尺只适合精度不太高的场合。
12. A method based on vernier caliper and digital image processing is introduced aiming at the calibration of micromanipulation system.
    本文针对微操作系统的作业标定问题，提出了一种基于游标卡尺和数字图像处理技术的方法。
13. Methods: Seventy extracted maxillary first premolars were used in this study. The Tooth Length, Crown Length, Root Length, Cervix Thickness, Cervix Width, Crown Thickness and Crown Width were measured with a vernier caliper.
    方法：收集牙齿发育完全根尖完整的上颌第一前磨牙70颗，用游标卡尺测量每个牙的牙长、冠长、根长、颈厚、颈宽、冠厚和冠宽。
14. Methods Using vernier caliper to measure the growth lengths of the fingernails, precisely calculated the daily growth rates.
    方法运用游标卡尺测量指甲生长长度，计算每日生长速率。
15. Various distances and angles were measured with dividers, protractor and vernier caliper.
    用游标卡尺、量角器和圆规分别测量各项数据。
16. Methods: The puncture was carried out on sixty cadaver specimens with puncture needle and measured with dynamometer and vernier caliper.
    方法：在60具尸体标本的胸骨上确定24个穿刺点（胸骨柄、胸骨角各3个穿刺点，胸骨体为18个穿刺点），用骨穿针、测力计及游标卡尺等进行测量。
17. The position of case handhole is usually measured with vernier caliper, but it's not accurate.
    手表表壳柄孔的位置度通常用游标卡尺测量，但用这种方法测量，表壳柄孔左右偏移量较大。
18. Methods The Grown Length, Root Length, Tooth Length, Grown Width, Crown Thickness, Cervix Length and Cervix Thickness were measured with a vernier caliper and SPSS software was adopted for analyzing correlation between different indexes.
    方法采用游标卡尺测量各牙位牙齿的冠长、根长、牙长、冠宽、冠厚、颈宽和颈厚；采用SPSS软件分析各指标间的相关性。
19. Methods During CABG, the lengths, the proximal and distal external diameter of RA and IMA were measured with vernier caliper respectively in 30 cases.
    方法采用游标卡尺分别测量CABG患者术中IMA、RA长度及近远端外径各30例；
20. Methods Infratemporal space and its adjacent of their anatomical relationship structures were observed in the selected 40 normal and symmetrical CT scans to measure in their diameters and their areas with vernier caliper and planimeter.
    方法选用40例扫描对称的正常CT片，观察颞下间隙及邻近结构的解剖学关系，利用游标卡尺及求积仪分别测量其径线和面积。
21. Method: Thirty dry samples of occiput were measured with vernier caliper and protractor.
    方法：用游标卡尺和量角器对30例成人干燥枕骨标本进行测量：（1）枕骨背面上项线区的测量；
22. At present, we use the vernier caliper to measure the diameter of steel rope by manual work.
    目前，厂矿企业仍沿用人工利用游标卡尺进行抽点检测法来测量提升钢丝绳的直径。
23. Method of measuring tooth morphology can be divided into two kinds of direct measurement and indirect measurement, direct measurement refers to the extracted teeth with vernier caliper for manual measurement, indirect measurement, including dental imaging method for measuring and plaster model of the measurement.
    牙齿外部形态测量的方法可分为直接测量和间接测量两种，直接测量是指用游标卡尺对离体牙进行手工测量，间接测量包括对牙齿的影像学测量和对牙合石膏模型的测量。
24. Use vernier caliper ( accuracy 0.02mm) and compasses, measure related important anatomic structures in surgical approach in this region.
    利用游标卡尺（精度0.02mm）和圆规，测量该区域手术入路相关的重要解剖结构。
25. Software vernier caliper method and Ellipse regress method for size inspecting of ellipse fruit were developed.
    提出了用于椭球形水果尺寸的椭圆回归法和软件卡尺方法。
26. All the measurements were done with vernier caliper.
    所有的测量均是通过游标卡尺进行测量（精确度为0.1mm）。
27. The apparent characteristics of corroded specimens were analyzed, the specimens were weighed before and after the test through electronic balance and vernier caliper, respectively, and the mass loss rate and corrosion depth of cement mortar specimens were obtained.
    对试件腐蚀后的表观特征进行了分析，并利用电子秤和游标卡尺分别对试验前后的试件进行称量，得到了水泥砂浆试件的质量损失率和腐蚀深度。
28. When the mass was palpable in axillary, tumor volume was measured with vernier caliper.
    当腋下触及肿块，游标卡尺测量肿瘤体积。
29. We measured the length of K-wire with vernier caliper.
    应用游标卡尺测量克氏针穿出长度。

noun

1. a caliper with a vernier scale for very fine measurements

   Synonym:    vernier micrometer